KEVOS® MAKEOS · Units
Decimal to Fraction
What is the nearest fraction to this decimal, and how far off is it?
Nearest fractional-inch size (to 1/8 … 1/128), the best fraction with a limited denominator (continued fractions) and the millimetre equivalent.
Open the calculatorRuns in your browser. No account needed.
How this tool works
Inputs, units and where to find them
| Input | Unit | Typical source |
|---|---|---|
| Decimal value | The decimal number, in inches for size work or a plain ratio. | |
| Fractional-inch resolution | choice | The smallest fraction step you can use, e.g. 1/64 for fractional drills. |
| Largest denominator for best fraction | Largest denominator allowed for the best-fraction approximation, e.g. the largest gear tooth count. |
Method and formulas
- Nearest fraction = round(value × N) ÷ N, reduced to lowest terms.
- Best fraction: continued-fraction convergents and semiconvergents of the value, keeping the closest with denominator ≤ the limit.
- Millimetres = inches × 25.4.
- Example: 0.4375 is exactly 7/16 in (11.1125 mm).
Limitations
- Negative values are not accepted; convert the magnitude.
- Example values are illustrations. Replace them with values for your actual task.
Typical uses
- Find the nearest fractional drill or stock size
- Approximate a ratio with small whole numbers for change gears
- Convert inch decimals to millimetres
Who it is for
- Machinists
- Toolmakers
- Design engineers
What you get
- Nearest fraction at the chosen resolution and its error
- Best fraction with a limited denominator and its error
- Millimetre equivalent
Interpreting the result
- For ratios, check the error against the accuracy the job needs (e.g. thread pitch error over the thread length).
References
- Machinery’s Handbook, 29th edition (Industrial Press, 2012), printed pp. 3, 11–13. Topic reference; no source tables or recommended settings are reproduced.
WORKOS tools are screening and decision-support utilities. Verify important financial, engineering, safety, legal or operational decisions using appropriate professional standards and your organisation’s approved data.
